Geotechnical properties of fresh municipal solid waste at Orchard Hills Landfill, USA

This paper presents the results of a laboratory investigation to determine the geotechnical properties of fresh municipal solid waste (MSW) collected from the working phase of Orchard Hills Landfill located in Davis Junction (Illinois, USA). Laboratory testing was conducted on shredded MSW to determine the compaction, hydraulic conductivity, compressibility, and shear strength properties at in-situ gravimetric moisture content of 44%. In addition, the effect of increased moisture content during leachate recirculation on compressibility and shear strength of MSW was also investigated by testing samples with variable gravimetric moisture contents ranging from 44% to 100%. Based on Standard Proctor tests, a maximum dry density of 420 kg/m(3) was observed at 70% optimum moisture content. The hydraulic conductivity varied in a wide range of 10(-8)-10(-4)m/s and decreased with increase in dry density. Compression ratio values varied in a close range of 0.24-0.33 with no specific trend with the increase in moisture content. Based on direct shear tests, drained cohesion varied from 31 to 64 kPa and the drained friction angle ranged from 26 to 30 degrees. Neither cohesion nor friction angle demonstrated any correlation with the moisture content, within the range of moisture contents tested. The consolidated undrained triaxial shear tests on saturated MSW showed the total strength parameters (c and phi) to be 32 kPa and 12 degrees, and the effective strength parameters (c' and phi') to be 38 kPa and 16 degrees. The angle of friction (phi) decreased and cohesion (c) value increased with the increase in strain. The effective cohesion (c') increased with increase in strain; however, the effective angle of friction (phi') decreased first and then increased with the increase in strain. Such strain-dependent shear strength properties should be properly accounted in the stability analysis of bioreactor landfills.     

Assessing the hydrocarbon degrading potential of indigenous bacteria isolated from crude oil tank bottom sludge and hydrocarbon-contaminated soil of Azzawiya oil refinery,Libya

The disposal of hazardous crude oil tank bottom sludge (COTBS) represents a significant waste management burden for South Mediterranean countries. Currently, the application of biological systems (bioremediation) for the treatment of COTBS is not widely practiced in these countries. Therefore, this study aims to develop the potential for bioremediation in this region through assessment of the abilities of indigenous hydrocarbonoclastic microorganisms from Libyan Hamada COTBS for the biotreatment of Libyan COTBS-contaminated environments. Bacteria were isolated from COTBS, COTBS-contaminated soil, treated COTBS-contaminated soil, and uncontaminated soil using Bushnell Hass medium amended with Hamada crude oil (1 %) as the main carbon source. Overall, 49 bacterial phenotypes were detected, and their individual abilities to degrade Hamada crude and selected COBTS fractions (naphthalene, phenanthrene, eicosane, octadecane and hexane) were evaluated using MT2 Biolog plates. Analyses using average well colour development showed that ~90 % of bacterial isolates were capable of utilizing representative aromatic fractions compared to 51 % utilization of representative aliphatics. Interestingly, more hydrocarbonoclastic isolates were obtained from treated contaminated soils (42.9 %) than from COTBS (26.5 %) or COTBS-contaminated (30.6 %) and control (0 %) soils. Hierarchical cluster analysis (HCA) separated the isolates into two clusters with microorganisms in cluster 2 being 1.7- to 5-fold better at hydrocarbon degradation than those in cluster 1. Cluster 2 isolates belonged to the putative hydrocarbon-degrading genera; Pseudomonas, Bacillus, Arthrobacter and Brevundimonas with 57 % of these isolates being obtained from treated COTBS-contaminated soil. Overall, this study demonstrates that the potential for PAH degradation exists for the bioremediation of Hamada COTBS-contaminated environments in Libya. This represents the first report on the isolation of hydrocarbonoclastic bacteria from Libyan COTBS and COTBS-contaminated soil.     

Triclosan in Fresh Water Fish Gibelion Catla from the Kaveri River,India, and Its Consumption Risk Assessment

Triclosan is a common antimicrobial agent that is found in significant levels in the aquatic environment and may elicit effects on aquatic organisms through unexpected modes of action. In this study, triclosan was quantified in fish from the Kaveri River, India, by using the gas chromatography and mass spectrometry technique and it was found in the range of 0.73–50 ng/g wet weight (ww). The mean bioaccumulation factor based on water (BAF_w 820) and sediment (BAF_s 2.12) in the Kaveri River showed that triclosan is accumulative in fish, and reflects its feeding behavior. The bioaccumulation indicates triclosan's persistence or prevalence throughout the river stretch. Human risk assessment through dietary intake demonstrated that the triclosan exposure is five orders of magnitude lower than the acceptable daily intake (50 μg/kg bw) and US EPA reference dose (300 μg/kg bw/day). This investigation is the first to report the bioaccumulation of triclosan in freshwater fish from India. Further, the results indicate that this fish acts as a biomarker of exposure for triclosan and thus shall be used to report triclosan pollution in the future.     

Biosorption kinetics of heavy metals by leaf biomass of Jatropha curcas in single and multi-metal system

Biosorption of Cu²⁺, Zn²⁺, and Cr⁶⁺ from aqueous solutions by leaf biomass of Jatropha curcas was investigated as a function of biomass concentration, initial metal ion concentration, contact time, and pH of the solution systematically. The aim of this study was to optimize biosorption process and find out a suitable kinetic model for the metal removal in single and multi-metal system. The experimental data were analyzed using two sorption kinetic models, viz., pseudo-first- and pseudo-second-order equations, to determine the best fit equation for the biosorption of metal ions Cu²⁺, Zn²⁺, and Cr⁶⁺ onto the leaf biomass of J. curcas in different metal systems. The experimental data fitted well the pseudo-second-order equation and provided the best correlation for the biosorption process. The findings of the present investigation revealed that J. curcas leaf biomass was an eco-friendly and cost-effective biosorbent for the removal of heavy metal ions from wastewater.     

Turbulent burst-sweep events around fully submerged vertical square cylinder over plane bed

Environmental Fluid Mechanics - The subtle variations of the turbulent shear stress affect the entrainment of bed sediments into the flow as well as sediment transport around submerged...     

Odor emission rate estimation of indoor industrial sources using a modified inverse modeling method

Odor emission rates are commonly measured in the laboratory or occasionally estimated with inverse modeling techniques. A modified inverse modeling approach is used to estimate source emission rates inside of a postdigestion centrifuge building of a water reclamation plant. Conventionally, inverse modeling methods divide an indoor environment in zones on the basis of structural design and estimate source emission rates using models that assume homogeneous distribution of agent concentrations within a zone and experimentally determined link functions to simulate airflows among zones. The modified approach segregates zones as a function of agent distribution rather than building design and identifies near and far fields. Near-field agent concentrations do not satisfy the assumption of homogeneous odor concentrations; far-field concentrations satisfy this assumption and are the only ones used to estimate emission rates. The predictive ability of the modified inverse modeling approach was validated with measured emission rate values; the difference between corresponding estimated and measured odor emission rates is not statistically significant. Similarly, the difference between measured and estimated hydrogen sulfide emission rates is also not statistically significant. The modified inverse modeling approach is easy to perform because it uses odor and odorant field measurements instead of complex chamber emission rate measurements.     

Simultaneous removal of organic compounds and heavy metals from soils by electrokinetic remediation with a modified cyclodextrin

Thousands of sites are contaminated with both heavy metals and organic compounds and these sites pose a major threat to public health and the environment. Previous studies have shown that electrokinetic remediation has potential to remove heavy metals and organic compounds when they exist individually in low permeability soils. This paper presents the feasibility of using cyclodextrins in electrokinetic remediation for the simultaneous removal of heavy metals and polycyclic aromatic hydrocarbons (PAHs) from low permeability soils. Kaolin was selected as a model low permeability soil and it was spiked with phenanthrene as well as nickel at concentrations of 500 mg kg-1 each to simulate typical mixed field contamination. Bench-scale electrokinetic experiments were conducted using hydroxypropyl beta-cyclodextrin (HPCD) at low (1%) and high (10%) concentrations and using deionized water in control test. A periodic voltage gradient of 2VDC cm-1 (with 5 d on and 2 d off) was applied to all the tests, and 0.01 M NaOH was added during the experiments to maintain neutral pH conditions at anode. In all tests, nickel migrated as Ni2+ ions towards the cathode and most of it was precipitated as Ni(OH)2 within the soil close to the cathode due to high pH condition generated by electrolysis reaction. The solubility of phenanthrene in the flushing solution and the amount of electroosmotic flow controlled the migration and removal of phenanthrene in all the tests. Even though high flow was generated in tests using deionized water and 1% HPCD, migration and removal of phenanthrene was low due to low solubility of phenanthrene in these solutions. The test with 10% HPCD solution showed higher solubility of phenanthrene which caused it migrate towards the cathode, but further migration and removal was retarded due to reduced electric current and electroosmotic flow. Approximately one pore volume of flushing resulted in approximately 50% removal of phenanthrene from the soil near the anode. Sustained higher electroosmotic flow with higher concentration cyclodextrin and maintaining low soil pH near cathode should be investigated to increase removal efficiency of both phenanthrene and nickel.     

Studies of mercury pollution in a lake due to a thermometer factory situated in a tourist resort: Kodaikkanal, India

Kodaikkanal, India, suffered mercury contamination due to emissions and waste from a thermometer factory. Kodai Lake is situated to the north of the factory. The present study determined mercury in waters, sediment and fish samples and compared the values with those from two other lakes, Berijam and Kukkal. Total mercury (Hg(T)) of 356-465 ng l(-1), and 50 ng l(-1) of mercury in methyl mercury form were seen in Kodai waters while Berijam and Kukkal waters showed significantly lower values. Kodai sediment showed 276-350 mg/kg Hg(T) with about 6% methyl mercury. Berijam and Kukkal sediments showed Hg(T) of 189-226 mg/kg and 85-91 mg/kg and lower methylation at 3-4% and 2%, respectively. Hg(T) in fish from Kodai lake ranged from 120 to 290 mg/kg. The results show that pollution of the lake has taken place due to mercury emissions by the factory.     

Inter-species differences for polychlorinated biphenyls and polybrominated diphenyl ethers in marine top predators from the Southern North Sea: Part 2. Biomagnification in harbour seals and harbour porpoises

Harbour porpoises (Phocoena phocoena) and harbour seals (Phoca vitulina) were found to differ in the ability to metabolize polychlorinated biphenyls (PCBs) and polybrominated diphenyl ethers (PBDEs). Biomagnification factors (BMFs), calculated between both predators and their prey (sole - Solea solea and whiting - Merlangius merlangus), had a large range of variation (between 0.5 and 91 for PCBs and between 0.6 and 53 for PBDEs). For the higher chlorinated PCBs and the highest brominated PBDEs, the BMF values in adult males were significantly higher than in the juvenile individuals of both species. BMF values of hexa- to octa-PCBs were the highest, suggesting reduced ability to degrade these congeners. Harbour porpoises had higher BMFs for lower chlorinated PCBs and for all PBDEs compared to harbour seals. Other factors, which may influence biomagnification, such as the octanol-water partition coefficients and the trophic level position measured through stable isotope (δ¹⁵N) analysis, were found to be of lesser importance to predict biomagnification in the studied food chain.     

Microbial degradation of pyridine using Pseudomonas sp. and isolation of plasmid responsible for degradation

Pseudomonas (PI2) capable of degrading pyridine was isolated from the mixed population of the activated sludge unit which was being used for treating complex effluents, the strain was characterized. Aerobic degradation of pyridine was studied with the isolated strain and the growth parameters were evaluated. Pyridine degradation was further conformed by chromatography (HPLC) analysis. The process parameters like biomass growth and dissolved oxygen consumption were monitored during pyridine degradation. In order to conform with the plasmid capability to degrade pyridine, the requisite plasmid was isolated and transferred to DH 5alpha Escherichia coli. The subsequent biodegradation studies revealed the ability of the transformed plasmid capability to degrade the pyridine.